A Clear Floor 2 post automotive lift version has no obstruction between the 2 posts.
They are considered ideal for when transmission jacks are constantly in use or cars with a low ride height.
The steel ropes and hydraulic pipes go over the top.
Product: 4 Ton manual release – Clear floor
Data Sheet: Download product specs
Certification: ISO 9000/9001 CE
*Colours and designs may differ
|When you have a power outage, the locks can still be released to lower the vehicle.
|Clear floor design
|The hydraulic hose and equalization cables run across the top of the lift through a metal bar (conduit) that connects both columns in the Overhead lift. The metal bar (conduit) is
there to guide the hose and cables and is not designed to support any vertical weight. There is a cut-off cable (connected to the power unit) located just below the metal overhead conduit which “kills” power to the motor preventing damage to the top of the car, if the lift operator was not paying attention.
|Stainless steel, strong and corrosion resistant.
|High strength chain drive system
|Dynamic test 115% of the rate capacity
|Ensures the hoist works correctly through its full cycle of operation
|Static test: 150% of the rated capacity
|Static load testing, to unsure the lifts can handle the recommended tonnage. Safety test.
|Dual anti skidding safety device from column ladder to hydraulic seal protection
|If the hydraulic system fails for some reason the vehicle on the lift will not fall, the lifts safety locks will lock into place to prevent any accidents.
|Designed to avoid overload running
|ABS control box, 24v low voltage control system
|Conforms to ISO standards and electrical components of the lift.
|High quality seals from Italy
|Seals can withstand high pressure and mechanical stress.
|Quality power rack
|Ensures safety at all heights.
|Conforms to CE requirements
|The CE Mark on a product or machine identifies it as complying with all the of safety requirements established by the European Union.
|Technicians can be professionally trained to use the machine and get the maximum benefit from it.
|1 year warranty
|The machine will be repaired if there are any factory faults and can be replaced if required.
|Should you have a breakdown you will not have to wait for your machine to be repaired. If there is anything we don’t have, we fly it in directly from the Suppliers.
|Technicians can learn how to operate the machine by watching a video, which is easier and more simple than written instructions.
• Lift must be installed indoors.
• Approved installers must be used when installing lifts or warranty will be void.
• All electrical connections must be done by a qualified Electrician, and each unit requires a separate isolator.
Lifting capacity: 4000kg
Maximum lifting height: 1900mm
Minimum lifting height: 85mm
Overall height: 3605mm
Overall width: 3426mm
Width between columns: 2803mm
Maximum vehicle width: 2576mm
Lifting time: 40s
Lowering time: 60s
Noise level: 70 dB(A0/1m
Average weight of package: 620kg
Power: 2.2 Kw
Flow rate: 4.8 cm³/g
Continuous working pressure: 170 bar – 190 bar
Peak pressure: 210 bar